Kichler 15064 Bedienungsanleitung PDF herunterladen

INSTRUCTIONS PERTAINING TO A RISK OF FIRE,OR INJURY TO

PERSONS

IMPORTANT SAFETY INSTRUCTIONS

Lighted lamp is HOT!

WARNING — To reduce the risk of FIRE OR INJURY TO PERSONS.

1) Turn off / unplug and allow to cool before replacing lamp.

2) Lamp gets HOT quickly! Contact only switch / plug when turning on.

3) Do not touch hot lens or cowl.

4) Do not remain in light if skin feels warm. (Light is intense, it may cause

“sunburn”.)

5) Do not look directly at lighted lamp.

6) Keep lamp away from materials that may burn.

7) Useonlywithwattageandlampmarkedonxture.

8) Do not touch the inner glass envelope of the lamp at any time. Use a soft

cloth. Oil from skin may damage lamp.

9) Donotoperatethexturewithadamagedormissinglens.

FOR USE WITH LANDSCAPE LIGHTING SYSTEMS ONLY.

1) The device is accepted as a component of a landscape lighting system

where the suitability of the CSA or UL labeled combination shall be deter

mined by CSA, UL respectively or the local inspection authorities having

jurisdiction.

2) Fixtureshallbeconnectedtoanextralowvoltagetransformerapproved

for use with landscape lighting systems.

3) Thisxtureistobeconnectedtoasecondarywiringofthefollowingtype:

12 GA 60°C minimum type;

SPT-3 suitable for outdoor use; or

approved landscape lighting cable.

Date Issued: 11/25/11 IS-15064-CB

OUTDOOR USE ONLY

DOM ETRE INSTALLE A L’EXTERIEUR

INSTRUCTIONS

For Assembling and Installing Fixtures in Canada

Pour L’assemblage et L’installation Au Canada

For warranty information please visit: http://www.landscapelighting.com/portal/warranty_page

Pour de plus amples informations sur la garantie, cliquez sur le lien ci-dessous : http://www.landscapelighting.com/portal/warranty_page

QUIC DISC

™

WIRING INSTRUCTIONS

Turn off power.

Thefulllengthofthe18GAxturewiremaybeusedtoconnectwiththe10GAor12GAcableprovidedthefollowingconditionsaremet:

•Wiringistobeprotectedbyroutingclosetothextureoraccessoryorsecuredtoabuildingstructuresuchashouseordeck.

• 18GAxturewiringistobecutoffsothatitisattachedtotheconnectorwithin6inchesofthextureorbuildingstructure.

• Ifitisnecessarytomaketheconnectionsunderground,thennomorethan6inchesofthe18GAxturewireistobeburied.

The Quic Disc

™

connector is designed to install onextureandaccommodatesone18GAxturewireandone 10 GA or one 12 GA supply wire.

Place the 10 gauge supply wire across the area marked 10 GA on Quic Disc

™

or place the 12 gauge supply wire across the area marked 12 GA

on Quic Disc

™

Placethe18gaugexturewireacrosstheareamarked18GAontheQuicDisc

™

. After the wires are in place, connecta the top of the Quic

Disc

™

tothebasewithsuppliedscrew,makingsurethatthewiresremainatinthebottomportionoftheQuicDisc

™

, and the screw is tightened

all the way down.

Thecoppercontactswillautomaticallypiercethewires’insulation.Excess18GAxturewirethatsticksouttheendoftheQuicDisc

™

is to be cut off.

Makenootherwiringconnectionstothe18GAxturewire.

CAUTION

WHEN INSTALLING KICHLER LANDSCAPE LIGHTING (LINE VOLTAGE OR LOW VOLTAGE),

CARE SHOULD BE TAKEN TO KEEP CLEAR OF POTENTIALLY COMBUSTIBLE MATERIALS.

WHEN MAINTAINING THE FIXTURES, BE SURE TO REMOVE LEAVES, PINE NEEDLES,

GRASS CLIPPINGS, MULCH, OR ANY DEBRIS THAT HAS ACCUMULATED ON THE LIGHT

BULB, LENS, OR BODY OF THE FIXTURE.

ASSEMBLY AND INSTALLATION

1) Loosensetscrewoneithersideofxtureface(donotremovescrews

completely) and remove face from housing.

2) Usingxturehousingasatemplatedeterminedesiredlocationforxture

and mark position of mounting holes on mounting surface.

3) Drill 1/8” pilot holes at positions marked in step 2.

4) Securexturehousingtomountingsurfaceusingprovidedscrews.

5) Installsuppliedlamptosocket.NOTE: Use caution when installing. DO

 NOTtouchlampwithbarehands.Ifthishappens,cleanlampwithdenatured

alcohol and a lint free cloth.

6) Reassemblexturefacetoxturehousing.

7) TURNOFFPOWER.

8) Make wire connections using supplied Quic Disc

™

following instructions

below, or using other approved wiring connection method (not supplied.)

HOUSING

BOÎTIERDULUMINAIRE

LAMP

AMPOULE

SCREW

VIS

SETSCREW

VISDERETENUE

FIXTUREFACE

PARTIEAVANTDULUMINAIRE

SOCKET

DOUILLE

1 2

Inhaltsverzeichnis

Seite 1 - Lighted lamp is HOT!

INSTRUCTIONS PERTAINING TO A RISK OF FIRE,OR INJURY TO PERSONSIMPORTANT SAFETY INSTRUCTIONSLighted lamp is HOT!WARNING — To reduce the risk of FIRE OR

Seite 2 - OU DE BLESSURE

INSTRUCTIONSPOUREVITERTOUTRISQUED’INCENDIEOU DE BLESSUREINSTRUCTIONS DE SECURITE IMPORTANTESUne lampe allumée est BRULANTE!AVERTISSEMENT — Pour

Weitere Dokumente für Beleuchtung Kichler 15064

Um das Dokument anzuzeigen Kichler 15064 Bedienungsanleitung

Kichler 15064 Bedienungsanleitung (2 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Kichler 15064 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Kichler 15064 herunter. Kichler 15064 Manuel d'utilisation Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Beleuchtung Kichler 15064

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung Kichler 15064