Kichler 15764 Bedienungsanleitung PDF herunterladen

SAFETY INSTRUCTIONS

READ THIS FIRST

KEEP THESE INSTRUCTIONS

This ﬁxture is intended for installation in accordance with the National

Electric Code (NEC) and Local code speciﬁcations. Failure to adhere to

these codes and instructions may result in serious injury and/or property

damage and will void the warranty.

1) WARNING: This ﬁxture is not to be installed within 10 feet (3M) of a pool,

spa or fountain.

2) This ﬁxture is to be used only with a power unit (transformer) rated a

maximum of 300 W (25 AMPS) 15 volts.

3) The #18 ga. ﬁxture wire is not intended for direct burial.

4) Direct burial rated wire is to be buried a minimum of 6” (152mm) beneath

the surface of the ground.

NOTE: If additional Direct Burial wire is needed, contact your local Kichler

landscape distributor.

 •8GAwirecanbepurchasedinlengthof250’(76M),15503-BK.

 •10GAwirecanbepurchasedinlengthof250’(76M),15504-BK.

 •12GAwirecanbepurchasedinlengthsof100’(30M),15501-BK;250’

  (76M),15502-BK;500’(152M),15505-BK;and1000’(304M),15506-BK.

5) Fixture shall not use a tungsten halogen lamp unless the ﬁxture is marked

for use with such lamps.

6) Wiring connections must be made with approved/listed wire connection

 device(s)suitablefortheapplication.Donotexceedmanufacturers’wiring

combination speciﬁcations for size and quantity of conductors.

WARRANTY

WE WARRANT THE LANDSCAPE PRODUCTS FEATURED IN OUR LANDSCAPE LIGHTING CATALOG (WITH THE EXCEPTION OF LIGHT BULBS) FOR FIVE YEARS AGAINST DEFECTS IN

MATERIALS AND WORKMANSHIP IF IT WAS PROPERLY INSTALLED AND FAILED UNDER NORMAL OPERATING CONDITIONS, PROVIDED IT IS RETURNED TO THE POINT OF PURCHASE,

WHERE IT WILL BE REPAIRED OR, AS IT MAY BE DETERMINED, TO REPLACE THE LANDSCAPE PRODUCT OR PARTS USED ON THAT PRODUCT.

DateIssued:5/7/10 IS-15764-US

Quic Disc

™

WIRING INSTRUCTIONS

Turn off power.

Thefulllengthofthe18GAxturewiremaybeusedtoconnectwiththe10GAor12GAcableprovidedthefollowingconditionsaremet:

•Wiringistobeprotectedbyroutingclosetothextureoraccessoryorsecuredtoabuildingstructuresuchashouseordeck.

• 18GAxturewiringistobecutoffsothatitisattachedtotheconnectorwithin6inchesofthextureorbuildingstructure.

• Ifitisnecessarytomaketheconnectionsunderground,thennomorethan6inchesofthe18GAxturewireistobeburied.

The Quic Disc

™

connector is designed to install one ﬁxture and accommodates one18GAxturewireandone10GAorone12GAsupplywire.

Placethe10gaugesupplywireacrosstheareamarked10GAonQuicDisc

™

orplacethe12gaugesupplywireacrosstheareamarked12GA

on Quic Disc

™

Placethe18gaugexturewireacrosstheareamarked18GAontheQuicDisc

™

. After the wires are in place, connecta the top of the Quic

Disc

™

to the base with supplied screw, making sure that the wires remain ﬂat in the bottom portion of the Quic Disc

™

, and the screw is tightened

all the way down.

Thecoppercontactswillautomaticallypiercethewires’insulation.Excess18GAxturewirethatsticksouttheendoftheQuicDisc

™

is to be cut off.

Makenootherwiringconnectionstothe18GAxturewire.

HOUSING

CUBIERTA PROTECTORA

FIXTURE FACE

CARA DEL ARTEFACTO

SCREW

TORNILLO

CAUTION

WHEN INSTALLING KICHLER LANDSCAPE LIGHTING (LINE VOLTAGE OR LOW

VOLTAGE), CARE SHOULD BE TAKEN TO KEEP CLEAR OF POTENTIALLY COMBUS-

TIBLE MATERIALS.

WHEN MAINTAINING THE FIXTURES, BE SURE TO REMOVE LEAVES, PINE NEEDLES,

GRASS CLIPPINGS, MULCH, OR ANY DEBRIS THAT HAS ACCUMULATED ON THE

LIGHT BULB, LENS, OR BODY OF THE FIXTURE.

ASSEMBLY AND INSTALLATION

1) Loosen set screw on either side of ﬁxture face (do not remove screws

completely) and remove face from housing.

2) Usingxturehousingasatemplatedeterminedesiredlocationforxture

and mark position of mounting holes on mounting surface.

3) Drill 1/8” pilot holes at positions marked in step 2.

4) Secure ﬁxture housing to mounting surface using provided screws.

5) Reassemble ﬁxture face to ﬁxture housing.

6) TURNOFFPOWER.

7) MakewireconnectionsusingsuppliedQuicDisc

™

following instructions

below, or using other approved wiring connection method (not supplied).

1 2

SAFETY INSTRUCTIONS 1

Inhaltsverzeichnis

Seite 1 - SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONSREAD THIS FIRSTKEEP THESE INSTRUCTIONSThis ﬁxture is intended for installation in accordance with the National Electric Code (NEC)

Seite 2

INSTRUCCIONES DE SEGURIDADPRIMERO LEA ESTOGUARDE ESTAS INSTRUCCIONESEste artefacto se debe instalar de acuerdo con el Código Eléctrico Nacional (NEC,

Verwandte Modelle: 16200 | 16202 | 15268 | 15315 | 15326 | 15426 | 15317 | 15421 | 15361 | 15165 | 15314 | 15191 |

Weitere Dokumente für Beleuchtung Kichler 15764

Um das Dokument anzuzeigen Kichler 15764 Bedienungsanleitung

Kichler 15764 Bedienungsanleitung (2 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Kichler 15764 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Kichler 15764 herunter. Kichler 15764 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: 16200 | 16202 | 15268 | 15315 | 15326 | 15426 | 15317 | 15421 | 15361 | 15165 | 15314 | 15191 |

Weitere Dokumente für Beleuchtung Kichler 15764

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung Kichler 15764